Average Reviews:
(More customer reviews)This would easily be a 5-star product with some minor improvements to setup documentation and configuration screens.
Pros:
* Great wireless range
* Compact design
* Reasonably fast re-boots as it is configured
Cons:
* In-box documentation is too skimpy for many people to set it up without a support call
* Configuration application lacks the supporting instructions supplied by other manufacturers (NetGear)
* A little pricey - but performance makes up for it
I use a LinkSys router in my home network, which has a default IP of 192.168.1.1. The DAP-2553 uses a default IP of 192.168.0.50, so have to change its IP to one that uses 192.168.1.x for it to work, and the in-box documentation does not tell you how do do this. Fortunately, D-Link's excellent product support got me going in a few minutes, and without grilling me about the product serial number or when I had purchased it (NetGear's support is a pain).
If you're setting up one of these on a LinkSys network, here's what you'll need to do:
* Connect your DAP-2553 directly to a computer using the enclosed Ethernet cable (with your computer's WiFi turned off)
* Manually set your computer's IP address to 192.168.0.54 (Go to Control Panel | Network | Change Adapter Settings, then right-click on Local Area Connection and select Properties. Select Internet Protocol 4, then Properties, then Use the following IP address. Put in IP, leave Subnet mask at 255.255.255.0, and set Default gateway to 192.168.0.50 to reach your DAP-2553). Hit OK.
* Open a browser and point it to 192.168.0.50
* Log in using the DAP-2553's supplied login info, and go to Basic Settings | LAN
* Set IP address to 192.168.1.50 (this puts it on the map for your LinkSys router)
* Set the default gateway to your LinkSys router's address - probably 192.168.1.1
* Select Apply
* Remember to re-set your computer's IP address back to DHCP, or whatever it was before (Assuming you were using DHCP - Go to Control Panel | Network | Change Adapter Settings, then right-click on Local Area Connection and select Properties. Select Internet Protocol 4, then Properties, then Obtain an IP address automatically). Hit OK.
* Disconnect your DAP-2553 from the computer and connect the DAP-2553 into your network.
* If it works, you should now find your DAP-2553 at 192.168.1.50 and be able to finish wireless configuration to your preferences.
* Rejoice.
Standard disclaimers apply. Good luck.
Click Here to see more reviews about: D-Link DAP-2553 Air Premier N Dual Band PoE Access Point, Selectable Dual Band Draft 802.11n
D-Link Air Premier N Dual Band POE Access Point, Selectable Dual Band Draft 802.11n
Get 17% OFF
0 comments:
Post a Comment